Knowledge Base - ACR-N が合格あるいは不合格ではなく N/A と表示される - LinkWare PC|www.flukenetworks.com/jp

ナレッジ・ベース

KB Home  >  全て

ACR-N shows N/A, not PASS or FAIL in LinkWare

In LinkWare, you may see ACR-N appear with N/A next to it rather than a PASS or FAIL. An example is shown below:
 
            LinkWare Not Available Result

If you are testing to any ANSI/TIA standard, you will always see N/A (Not Applicable) next to ACR-N since ACR-N is not a requirement in ANSI/TIA standards. It is however reported because many customers expect to see ACR-N on the test report. The limit line on the graph should ideally be black and not red; an enhancement request has been made to engineering.

ISO/IEC standards do require ACR-N. However, you may also see N/A appear if the Insertion Loss of the disturbed pair is less than 4 dB for the entire measurement frequency; often referred to as the 4 dB rule. It only applies to ISO/IEC Permanent Link testing and NOT Channel testing.

Conclusion
There is no corrective action for you to take. Your tester and LinkWare are following the standard you selected.

記載者:Adrian Young

Creation Date: 2014-02-25

Last Modified: 2017-04-10

 
 
 
 
Powered By OneLink